Fire | Original | A | 2/12/2002 | TERESA | TERESA | 2-11-02 smc (plan #20120125) | | Fire | 157970 | Plumbing | Original | A | 2/7/2002 | RUSSELL | RUSSELL | | | Plumbing | 157974 | Mechanical | Original | A | 2/7/2002 | RUSSELL | RUSSELL | | | Mechanical | 157971 | Construction | Original | A | 2/5/2002 | TIMC | TIMC | | | Construction | 157967 | Out to Review | Original | A | 1/7/2002 | ANGELA | ANGELA | jody bush has plans | | Out to Review | 157973 | Electrical | Original | A | 1/4/2002 | JERRY | JERRY | | | Electrical | 157969 | Out to Review | Original | A | 1/2/2002 | JERRY | JERRY | jerry | | Out to Review | 157972 | Plumbing | Original | D | 12/31/2001 | RUSSELL | RUSSELL | Based on occupant loads, how complying with '99 PPRBC section 413.5 and Table 413, mop sink requirements in finished space ?, size schedulin of water heaters ?, in WH-3 instantaneous ?, venting of S-1 shall be a minimum of 6" above flood level rim before off-setting horizontally, vent for standpipe missing, how is 2" standpipe adequate when dumping a 2", 1 1/2" and 2- 1" pipes into it, end of line cleanouts required as indicated on isometrics, wall cleanouts required at urinal locations per '97 UPC section 707.4, sump requirements per '97 UPC section 710.4, | | Plumbing | 157992 | Mechanical | Original | D | 12/31/2001 | RUSSELL | RUSSELL | Building is Type II 1 hour, how maintaining 1 hour floor/ceiling assembly fwith duct penetrations, is ceiling part of 1 hour assembly ?, based on occupant loads sheet AF-00 and units supplying 20 % O.A. how complying with '97 UBC section 1202 allowing the 1/2 rule in conference and break rooms only, also how complying with '97 UBC section 1202 for O.A requirements in classrooms (1/2 rule not allowed), exhaust fan duct at elevator equipment room penetrating 1 hour occupancy separation requires F/S damper plus duct must go to exterior of building, not allowed to dump into ceiling R.A. plenum, verify exhaust ventilation adequate per '97 UBC Table A-12-A under 'B' occupancy with required fixture count, based on total occupant loads how complying with O.A. quantities with units set at 20 %, AHu-09-05not supplying 20% O.A., Ceiling height between finished and unfinished area for R.A. path ?, how otaining adequate O.A. beyond minimums, interlocking of AHU's with exhaust + more | | Mechanical | 157991 | Construction | Original | D | 12/21/2001 | TIMC | TIMC | Specify all gyp board to be 5/8" type "X". Speocify location of rated ceilings/floors. Specify how you are maintaining 1-hr floor/ceiling rating with new penetrations. Exiting from classrooms you are allowed only 1 intervening room, provide rated corridor to exits or open up hall to office area. 1 day recheck. | | Construction | 157968 |
|
| |
|